IBM totalstorage 200, Service Manual

Page: 94 / 180

3. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the socket.
4. Reinstall the appliance cover and connect the cables.
Note: Wait approximately 20 seconds after you plug the power cord of your
appliance into an electrical outlet for the Power Control button to become
active.
5. Switch on the appliance.
6. Start the Configuration/Setup Utility program and set configuration parameters.
v
Set the system date and time.
v
Set the power-on password.
v
Reconfigure your appliance.
Replacing the fan assembly
Your appliance comes with two fan assemblies.
Attention: Replace a fan that has failed within 48 hours to help ensure proper
cooling.
Figure 35 on page 79 shows the replacement of a fan assembly.
Figure 33. Replacing the battery
Figure 34. Installing the battery
78
Models 200 and 225 Service Guide