IBM System x3610, Problem Determination And Service Manual

Page: 82 / 144

6. Remove the screws that secure the front USB connectors to the DVD drive
cage assembly.
7. Disconnect the USB cables from the system board and remove them from the
clips that are on top of the DVD drive cage assembly.
8. Lift the USB connectors off the CD/DVD drive cage assembly.
9. If you are instructed to return the USB connector assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the front USB connectors
To install the replacement front USB connectors, complete the following steps.
1. Align the front USB connectors with the opening in the flange on top of the DVD
drive cage assembly.
2. Attach the screws that secure the front USB connectors to the DVD drive cage
assembly.
3. Place the cables through the clips that are on top of the DVD drive cage
assembly
4. Install the DVD drive cage assembly into the server.
a. Lower the drive-cage enclosure into the server; then, slide the enclosure
toward the front of the server until it is flush with the front of the chassis.
b. Replace the screws that secure the drive-cage enclosure to the chassis.
5. Install the fan-bracket assembly (see “Installing the fan-bracket assembly” on
page 68).
6. Route the USB cables in front of the fans and connect them to the system
board. See “System-board internal cable connectors” on page 9 for the
connector location.
7. Install the cover (see “Installing the cover” on page 46).
8. Slide the server into the rack and tighten the rack release thumbscrews.
64
IBM System x3610 Type 7942: Problem Determination and Service Guide