Removing a 3U chassis from a Type 7825 iDataPlex rack
To remove the 3U chassis from a Type 7825 iDataPlex rack, complete the following
steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
2. Turn off the server and all attached devices (see “Turning off the system-board
3. If external cables are connected to the front of the system-board tray, note
where they are connected; then, remove them.
4. Note where the hard disk drives are installed; then, remove them (see
“Removing and installing a hard disk drive” on page 88).
Statement 4:
≥
18 kg (39.7 lb)
≥
32 kg (70.5 lb)
≥
55 kg (121.2 lb)
CAUTION:
Use safe practices when lifting.
5. Remove the screws and slide the 3U chassis from the iDataPlex rack.
6. Set the 3U chassis on a flat, static-protective surface.
7. If you are instructed to return the 3U chassis, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components
129
