Installing a power-supply paddle card in an expansion enclosure
Note:
The following information describes how to install a power-supply paddle
card in an I/O enclosure. Installing the power-supply paddle card in another
type of expansion enclosure is similar.
To install a power-supply paddle card in an expansion enclosure, complete the
following steps.
1. Touch the static-protective package that contains the power-supply paddle card
to any
unpainted
metal surface on the outside of the expansion enclosure; then,
remove the power-supply paddle card from the package.
2. Place the power-supply paddle card on the mounting studs in the expansion
enclosure and install the four retaining screws.
3. Reconnect the power-supply paddle card cables.
4. Install the 3.5-inch simple-swap drives, if you removed any when you removed
the power-supply paddle card. Complete the following steps:
a. Install the hard disk drive bracket and cable assembly (see “Removing and
installing a one-bay or four-bay hard disk drive bracket and cable assembly”
on page 108).
b. Reconnect the hard disk drive bracket and cable assembly cables.
c. Install the 3.5-inch hard disk drive (see “Installing a 3.5-inch simple-swap
5. Install the expansion enclosure (see “Installing an expansion enclosure on a
system-board tray” on page 74).
6. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 76).
118
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
