IBM System Storage TS7600 ProtecTIER Series, Installation Roadmap Manual, Page: 123 / 232

v Voice phone number
v
Disk array machine type and model number
v Disk array serial number
v
Customer number
v Country code
Note:
This is the two-digit, IBM-assigned country code used to order software or
to acquire software support. Do not confuse this with the three-digit RETAIN
country code.
v
Simple Mail Transfer Protocol (SMTP) server IP address (optional)
v
Customer e-mail address (optional)
Procedure
1. Establish a connection to the server. To do so:
a.
Attach a USB keyboard to any open USB port on the back of the server.
b. Attach a graphics-capable monitor to the video port on the back of the
server.
Note: If you are unable to connect to the server using the above procedure,
see Appendix D, “Making a server connection through the System
Management Module (IMM),” on page 155 for instructions on connecting to
the server using the server's RSA and your service laptop or the TSSC.
2. At the server command prompt, log in with the ID root and the password
admin
.
Note: During the boot cycle, the ProtecTIER file systems are mounted. If the
message: Running... displays, press <enter> to proceed to the login prompt.
3. Start RAS configuration on the server using the following method:
From the command line
a. Change the directory. Type: cd /opt/dtc/install <enter> .
b. Type: ./ptconfig -configRas <enter>.
(You may need to enter the entire command string: /opt/dtc/install/ptconfig
-configRas
).
c.
Follow the on-screen instructions to complete the configuration process.
Note:
If you receive an error that the frame range number entered is
already in use, specify a different range in an increment of 10. For example,
if frame range 20 is already in use, try frame range 30.
4. When RAS configuration is complete, go to Chapter 7, “RAS verification,” on
page 91.
Clustered Configuration
Use this section to configure RAS on a clustered TS7650G.
About this task
If you are configuring the RAS package on the servers in a clustered configuration,
follow the procedures below.
– OR –
Chapter 6. Configuring the RAS package
85