IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 88 / 257

4-10
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Configuring Network Settings
Figure 4-22. Network settings
Use Configuration
→
Configure Network Settings to set the network settings for the
library.
Note: The internet protocol (IPv4, IPv6 or dual IPv4/IPv6) selection is used for the
TS2900 Tape Autoloader IP address, subnet mask, gateway address, time
server address, mail server address, SNMP trap address, and EKM server
addresses.
Configure the network using the following settings:
•
Link Speed — Ethernet duplex mode (Auto, 10Base-T Full, 10Base-T Half,
100Base-TX Full, 100Base-TX Half).
• DHCP — (Dynamic Host Configuration Protocol) Enable DHCP to have the library
server or router negotiate the connection with the library.
–
IPv4 — Select to enable DHCP using the IPv4 protocol.
– IPv6 — Select to enable DHCP using the IPv6 protocol
Enable DHCP IPv6
Disable DHCP IPv6
Set IP Address IPv4
Set IP Address IPv6
Change Subnet Mask
Set Subnet Mask
Set Prefix Length
Configuration
Configure Network Settings
Configure Link Speed
Set Auto Negotiation
Set 10 Base-T Full
Set 10 Base-T Half
Set 100 Base-T Full
Set 100 Base-T Half
Configure DHCP
Configure DHCP IPv4
Enable DHCP IPv4
Configure DHCP IPv6
Change IP Address
Change Gateway
Set Gateway Address IPv4
Set Gateway Address IPv6
Disable DHCP IPv4
Input IP Address
Input IP Address x 4
Input Subnet Mask
Input Prefix
Input Gateway
Input Gateway x 4