IBM System Storage TS2230, Setup, Operator, And Service Manual

Page: 108 / 141

1
Loader motor worm gear
3
Takeup reel motor
2
Outer guide rail
WARNING: DO NOT
TOUCH
4
Supply reel motor
7. Reassemble the drive by reversing the procedure in Step 4 in “Beginning
Procedure” on page E-5.
8. Reassemble the chassis by reversing the steps in “Removing a Drive from an
Enclosure” on page E-1.
9.
Allow the drive to perform mid-tape recovery. This takes several minutes.
When this activity completes, push the Unload button to eject the cartridge.
10. Test the drive (see “Function Code 1: Run Drive Diagnostics” on page 3-9) to
determine if it should be replaced.
Tape Tangled along Tape Path
1. Carefully pull out excess tape and untangle.
Note: If you find the tape to be broken, go to one of the following appropriate
procedures:
v
“Tape Spooled off Supply Reel” on page E-6
v “Tape Pulled from or Broken near Leader Pin” on page E-8
--OR--
“Tape Broken in Mid-tape” on page E-9
2. Set the drive on its left side with the head and tape path facing up.
3
4
1
2
a82hd002
Figure E-9. Rewinding tape into cartridge
E-10
TS2230 Tape Drive Setup, Operator and Service manual