IBM System Storage DS3000, Programming Manual

Page: 352 / 652

Start Storage Subsystem iSNS Server Refresh
This command initiates a refresh of the network address information for the iSNS server. If the DHCP
server is marginal or unresponsive, the refresh operation can take from two to three minutes to complete.
Note: This command is for IPv4 only.
Syntax
start storageSubsystem isnsServerRefresh
Parameters
None.
Notes
If you used the
set storageSubsystem isnsIPv4ConfigurationMethod
command to set the configuration
but did not set the configuration to DHCP, running the
start storageSubsystem isnsServerRefresh
command returns an error.
Stop array locate
This command turns off the indicator lights on the disk drives that were turned on by the start array
locate
command.
Syntax
stop array locate
Parameters
None.
Stop Cache Backup Device Diagnostic
This command stops the cache backup device diagnostic tests that were started by the
startcacheBackupDevice diagnostic
command.
Syntax
stop cacheBackupDevice controller [(a | b)] diagnostic
Parameters
Parameter Description
controller
The controller that has the cache backup device on which
you are running the diagnostic tests. Valid controller
identifiers are
a
or
b
, where
a
is the controller in slot A, and
b
is the controller in slot B. Enclose the controller identifier
in square brackets ([ ]). If you do not specify a controller, the
storage management software returns a syntax error.
Stop Cache Memory Diagnostic
This command stops the cache memory diagnostic tests that were started by the
start
cacheMemorydiagnostic
command.
3-306
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide