IBM System Storage DS3000, Programming Manual

Page: 322 / 652

Show Storage Subsystem Diagnostic Data Capture
This command show details of the diagnostic data capture on the controller cache, if a diagnostic data
capture is available.
Syntax
show storageSubsystem ddc
Parameters
None.
Show Storage Subsystem Features
This command lists the feature configuration of a storage subsystem. This command returns information
that shows which features are enabled, disabled, evaluation, and available to be installed.
Syntax
show storagesubsystem features
Parameters
None.
Notes
This command returns the feature information in a format similar to this example.
PREMIUM FEATURE STATUS
driveSlotLimit Enabled (12 of 192 used)
SSDSupport Disabled - Feature Key required
highPerformanceTier Disabled - Feature Key required
remoteMirror Disabled/Deactivated - Feature Key require
safeStoreExternalKeyMgr Disabled - Feature Key required
safeStoreSecurity Disabled - Feature Key required
VolumeCopy Disabled - Feature Key required
Show storage subsystem unconfigured iSCSI Initiators
This command returns a list of initiators that have been detected by the storage subsystem but are not yet
configured into the storage subsystem topology.
Syntax
show storageArray unconfiguredIscsiInitiators
Parameters
None
Minimum Firmware Level
7.10
3-276
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide