IBM System Storage DS3000, Programming Manual

Page: 281 / 652

Parameters
Parameter Description
errorAction
How the session responds if an error is
encountered during processing. You can choose
to stop the session if an error is encountered, or
you can continue the session after encountering
an error. The default value is
stop
. (This
parameter defines the action for execution
errors, not syntax errors. Some error conditions
might override the
continue
value.)
password
The password for the storage subsystem.
Enclose the password in double quotation
marks (“ ”).
performanceMonitorInterval
The frequency of gathering performance data.
Enter an integer value for the polling interval, in
seconds, for which you want to capture data.
The range of values is
3
to
3600
seconds. The
default value is
5
seconds.
performanceMonitorIterations
The number of samples to capture. Enter an
integer value. The range of values for samples
captured is
1
to
3600
. The default value is
5
.
Notes
When you use this command, you can specify one or more of the optional parameters.
Passwords are stored on each storage subsystem in a management domain. If a password was not
previously set, you do not need a password. The password can be any combination of alphanumeric
characters with a maximum of 30 characters. (You can define a storage subsystem password by using the
set storageSubsystem
command.)
The polling interval and the number of iterations that you specify remain in effect until you end the
session. After you end the session, the polling interval and the number of iterations return to their default
values.
Set Storage Subsystem
This command defines the properties of the storage subsystem.
Syntax
set storageSubsystem alarm=(enable | disable | mute)|
{autoSupportConfig (enable | disable) |
cacheBlockSize=
cacheBlockSizeValue
cacheFlushStart= cacheFlushStartSize
cacheFlushStop= cacheFlushStopSize
defaultHostType=(“ hostTypeName ” | hostTypeIdentifier )
failoverAlertDelay= delayValue |
mediaScanRate=(disabled | 1-30) |
password=”
password ” |
userLabel=” storageSubsystemName ”
isnsRegistration=(TRUE | FALSE))
Chapter 3. Script Commands
3-235