IBM System Storage DS3000, Programming Manual

Page: 216 / 652

Note: You cannot use this command for an Enhanced FlashCopy logical drive that is used in online
logical drive copy.
Syntax
revive enhancedFlashCopyLogicalDrive [enhancedFlashCopyLogicalDriveName]
Parameters
Parameter Description
enhancedFlashCopyLogicalDrive
The name of the Enhanced FlashCopy logical drive that
you want to set to the
Optimal state. Enclose the
Enhanced FlashCopy logical drive name in square
brackets ([ ]).
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
Revive Array
This command forces the specified Array and its associated failed drives to the Optimal state.
ATTENTION Possible loss of data access – Correct use of this command depends on the data
configuration on all of the drives in the Array. Never try to revive a drive unless you are supervised by
your Technical Support representative.
Syntax
revive volumeGroup [volumeGroupName]
Parameter
Parameter Description
volumeGroup
The alphanumeric identifier (including - and _) of the
Array to be set to the Optimal state. Enclose the Array
identifier in square brackets ([ ]).
Minimum Firmware Level
6.10
Save Enhanced Global Mirror Group statistics
This command saves to a file the synchronization statistics for one or more member volumes in an
Enhanced Global Mirror Group. The statistics collected are available only for Enhanced Global Mirror
Group member volumes in a primary role on the local storage subsystem.
A set of data is collected during the synchronization process that can be used to evaluate how well the
mirror configuration is functioning. The data is collected as a set of
samples
. A sample is created at the
beginning of a synchronization process and updated regularly while the synchronization process
proceeds.
3-170
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide