IBM SureMark 4610 1NF, Hardware Service Manual

Page: 31 / 112

Chapter 3. Adjusting and maintaining the SureMark 4610
Model 1NF printers
This section contains information about the proper use and maintenance of the SureMark 4610 Model 1NF
single-station printers. For detailed technical information, see Chapter 2, “Product specifications,” on page
11.
Attention: Ensure that all covers are installed before operating the printer.
Using and maintaining the printer
Replenishing consumable supplies
The end user is responsible for replenishing the supply roll paper.
Loading and replacing the paper roll
1. Press the blue release button to open the paper cover.
2. If necessary, remove any unused paper or the empty paper roll core before inserting a new paper roll.
Refer to the label inside the printer for a diagram of how to load paper.
3. Place the paper roll into the paper roll bucket as shown on the diagram. The leading edge of the paper
should come from the bottom of the roll as shown in the diagram.
Note: The thermal printhead will not print on paper with glue on it. If the new paper roll was sealed by
glue, tear off the 6 to 8 inches of paper with glue on it before loading it.
4. Close the paper cover.
5. Press the customer receipt feed button to advance the paper and verify that the paper is feeding
correctly. Feed approximately 1 ft (30 cm) of paper to test for correct alignment.
Attention: Do not pull the receipt paper out of the printer with the paper access cover closed. This
disengages the paper feed. The paper feed motor must then catch up before the printer can feed the
paper, which causes missing lines or partial lines of print. Use the customer receipt feed button to advance
the receipt and all lines will print.
© Copyright IBM Corp. 2010
17