IBM SureMark 4610 1NF, Hardware Service Manual

Page: 75 / 112

d. Align the end of the spring leg with the slot and hole in the paper door assembly; then, rotate the
bottom of the spring toward the front of the printer unit and insert the hooked end into the mounting
slot.
e. Repeat steps 5a on page 60 through 5d to install the remaining spring; then, continue to the next
step.
6. Install the cutter motor:
a. Align the mounting holes in the motor with the holes in mounting bracket.
b. Install the mounting screws and secure the cutter motor.
7. Route the wires from the cutter motor and paper door assembly around the right side of the printer unit
frame.
8. Connect the cable to the logic card; then install the logic card (see “Installing the logic card” on page
56 for information on how to install the logic card).
9. Install the main and paper door covers (see “Installing the main cover” on page 46 and “Installing the
paper door cover” on page 42).
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs
61