Procedure
1.
Use the slide rails to pull the enclosure out of the rack, as described in
“Removing an expansion enclosure from a rack: 2076-92F” on page 92. Ensure
that a mechanical lift is available to support the weight of the enclosure.
Remove the front (4U) fascia
2.
Remove the front fascia by removing the two screws that attach the fascia to
the flange on each side of the chassis, as shown in Figure 76 on page 84.
x4
svc01042
Figure 75. Fascia components on the expansion enclosure
Chapter 2. Installing the Storwize V7000 Gen2 and Storwize V7000 Gen2+ hardware
83
Summary of Contents for StorVize V7000 Gen2
