IBM ServeRAID-4 Ultra160 Series, User Reference

Page: 99 / 208

Chapter 10. Installing and starting the ServeRAID Manager
program
After installing the operating system on your server, you can install the ServeRAID
Manager program on your server. The ServeRAID Manager program provides a
graphical interface that you can use to monitor ServeRAID configuration changes
being performed on your server while your server is fully operational. You can
create an array, delete an array, create a logical drive, change the RAID level,
dynamically increase the logical drive size, rebuild an array, configure your
ServeRAID controllers in a failover environment, configure a cluster, and perform
other ServeRAID configuration functions.
To use the ServeRAID Manager program, see the ServeRAID Manager online help
or refer to “Configuring the ServeRAID controller” on page 28.
Installing the ServeRAID Manager program
This section provides instructions for installing the ServeRAID Manager program.
When using: Go to:
Windows 2000 “Installing ServeRAID Manager on Windows 2000, Windows NT 4.0,
Windows 98, or Windows 95” on page 82.
Figure 21. ServeRAID Manager installed on a server
© Copyright IBM Corp. 2001
81