IBM SCM, Manual

Page: 21 / 54

b. Place the CP SCM tool over the module while ensuring that the CP SCM tool dowel holes align
with the dowel pins on the LGA load frame (B). Also, make sure the (A01) corner of the CP SCM
tool lines up with the (A01) label on the load frame.
c.
While holding the CP SCM tool down, carefully close the latch by pressing the center pushbutton
down. After the center pushbutton has been pressed, ensure that the two wings (C) are released
from the latches (A) and that the wings are at about the same level as latches.
d. Lightly push down on the CP SCM tool and CP SCM module.
e. Slowly lift the CP SCM tool and CP SCM module straight up and out of the drawer by holding
on to the ring if the SCM tool has a ring, otherwise grasp the sides of the tool.
f. Place the failing CP SCM module on a clean, flat surface and release the module by pushing the
pushbutton down with one hand.
Note: If installing a new SCM module, the packaging tray (P/N 00E8478) will be used for
returning the failing module.
g. Squeeze the two latches (A) with the other hand and ensure the wings (C) on the pushbutton get
into the slots of the latches securely.
h. Lift the CP SCM tool straight up.
If performing this procedure from a management console, close this web page to continue with the
procedure.
Remove SCM
17