6.
The Status LED on the blade will show amber until POST completes for the
blade. It should then display green. If it remains amber, the board may not be
properly seated in the backplane or the board may be faulty.
7.
Install the transceivers and cables in the blade. For mSFP transceivers (FC8-64
port blade only) and QSFP (FC16-64 port blade only), it is recommended that
you install the cables in the transceivers before installing the transceivers in the
blade.
8.
Group and route the cables through the cable management comb.
9.
Install the chassis door.
Note:
The FS8-18 encryption blade requires additional configuration to enable
encryption. See “Configuring for encryption (optional)” on page 49.
Removing and installing blade filler panels
This section describes how to remove and install port blade filler panels.
Note:
Some filler panels have two thumbscrews and some have only one. Be sure
to unscrew or tighten both if you are using the two-screw version.
Removing a filler panel
Attention:
A filler panel should be removed only when being replaced with a
port or application blade or new filler panel. Any slot that is not occupied by a
blade should be occupied by a filler panel to ensure correct cooling of the chassis
and protection from dust.
Complete the following steps to remove a filler panel.
1.
Remove the chassis door.
2.
Unscrew the thumb screws on the panel using a Phillips screwdriver.
3.
Using the tabs, pull the filler panel out of the chassis. (See Figure 32 on page
88.)
Chapter 5. Removing and installing components
87
|
|
|
|
Summary of Contents for SAN768B-2
