IBM SAN256B-6, Installation, Service And User Manual

Page: 37 / 292

18-32 kg (39.7-70.5 lbs)
svc00167
Note:
Do not attempt to lift the device by the protective cover attached to the air vents on
the nonport-side of the chassis.
18-32 kg (39.7-70.5 lbs)
svc00167
DANGER
If a lift tool is not available, the director chassis must be depopulated completely
before installing it into the rack. Remove the power supplies, fan modules, all of the
blades, the cable management fingers, and the chassis door (if equipped). Install the
empty chassis into the rack following the chassis installation instructions. The weight
of the empty chassis is 54 lb (24.5 kg) and must be lifted by minimum 2 people. After
securing the chassis to the rack, reinstall the power supplies, fan modules, and the
blades and proceed with the installation.
Laser precautions
DANGER
All fiber-optic interfaces use Class 1 lasers.
DANGER
Laser Radiation. Do Not View Directly with Optical Instruments. Class 1M Laser
Products.
DANGER
Use only optical transceivers that are qualified by IBM and comply with the FDA
Class 1 radiation performance requirements defined in 21 CFR Subchapter I, and with
IEC 825 and EN60825. Optical products that do not comply with these standards might
emit light that is hazardous to the eyes.
Facility requirements
Before installing the device, be sure the following facilities requirements are met.
Table 4. Facility requirements
Type Requirements
Device specifications Ensure that the facility can accommodate system, power, and environmental
specifications for this device as outlined in the Appendix B, “Product Specifications,”
on page 231.
Preparing for the Installation
9