4.
Pull the SAN Volume Controller 2145-8A4 node completely out of the slides.
Removing the SAN Volume Controller 2145-8G4 from a rack
Use these instructions when you are prompted to remove a SAN Volume Controller 2145-8G4 from a
rack.
If the SAN Volume Controller is not already turned off, see "Turning off the SAN Volume Controller
node" in the
IBM System Storage SAN Volume Controller Troubleshooting Guide
.
Attention:
Do not touch the power control switches on adjacent SAN Volume Controller nodes when
you remove or install SAN Volume Controller nodes in a rack. Touching these switches on adjacent SAN
Volume Controller nodes might cause those devices to turn off and make customer data inaccessible.
Use the reference numbers in parentheses at the end of each notice, such as (C003) for example, to find
the matching translated notice in
IBM System Storage SAN Volume Controller Safety Notices
.
Figure 34. The captive thumbscrews that secure the node and the shipping brackets
Chapter 2. Removing and replacing parts
51
|
|
Summary of Contents for SAN Volume Controller 2145-CG8
