IBM SAN Volume Controller 2145-CF8, Hardware Installation Manual

Page: 56 / 101

Installing the SAN Volume Controller 2145-CF8 in a rack
After installing the support rails, you can install the SAN Volume Controller
2145-CF8 node in the rack.
CAUTION:
To avoid any hazard from the rack tipping forward when devices are installed,
observe all safety precautions for the rack into which you are installing the
device.
To install the SAN Volume Controller 2145-CF8 node in the rack, perform the
following steps:
1. Place the SAN Volume Controller 2145-CF8 in the rails on the rack.
a. Pull the slide rails forward until they click twice into place.
See
1
in Figure 30 on page 31.
b. Lift the node and carefully tilt it into position over the slide rails. Line up
the rear nail heads
2
on the node line up with the rear slots
3
on the
slide rails.
c. Slide the node down until the rear nail heads slip into the two rear slots.
d.
Lower the front of the node
4
until the other nail heads slip into the other
slots on the slide rails.
e. Verify that the front latch
5
slides over the nail heads.
svc00547
1
Figure 29. SAN Volume Controller 2145-CF8 cables in the cable-management arm
30
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide