IBM RS/6000 44P Series 270, User Manual

Page: 100 / 216

Press Enter when you are finished; you must type the password again for verification.
If the two password entries do not match, an error icon displays with a message:
Password was attempted to be set
and an error code
Power-On Access: 20E00000
displays.
Note: If you forget the Power-On Access password, you can erase the password by
shutting down the system unit and removing the battery for at least 30 seconds.
A password becomes effective only after the system is turned off and back on again.
Remote Mode: The remote mode, when enabled, allows the system to start from the
defined boot device. This mode is ideal for network servers and other system units that
operate unattended. When the remote mode is set, the icon label changes to Remote
<On>.
Enter Password
Verify Password
82
44P Series Model 170 User’s Guide