IBM RackSwitch G8000, Installation Manual

Page: 26 / 86

Table 6. Console connector wiring (continued)
D9 Pin number Wire Mini-USB
Pin 1 D9 pins 1, 4, and 6 are connected
Pin 4
Pin 6
Pin 7 D9 pin 7 is connected to D9 pin 8
Pin 8
Shell Braid Shell
10 Gigabit Ethernet port expansion slots
The RackSwitch unit includes two port expansion slots, one on the front panel and
one on the rear panel. Each expansion slot accepts a dual-port 10 GbE (XGE)
uplink module for either CX4 or Small Form-factor Pluggable Plus (SFP+).
You can add one or two XGE uplink modules, as follows:
SFP+ Uplink Module
Up to four 10 Gbps SFP+ modules can be installed on the RackSwitch. These ports
accept approved optical SFP+ transceivers. SFP+ transceivers can be purchased
separately.
CX4 Uplink Module
Up to four CX4 ports can be installed on the . These ports provide CX4 connectivity
between the RackSwitch and copper 10 GbE CX4 network devices. The CX4 ports
support link spans up to 15 meters on appropriate CX4-grade copper cables.
The CX4 ports provide powered CX4 automatically. The port detects when a
powered CX4 device is connected, and sends power to the device.
The RackSwitch is designed to accept most standard 10 GbE CX4 cables. For the
available transceivers and direct attach cables (DACs) for the switch, see:
https://www-01.ibm.com/products/hardware/configurator/americas/bhui/launchNI.wss.
Note: Do not use InfiniBand CX4 cables with the RackSwitch. Although InfiniBand
cables have the same CX4 connectors as 10GBase-CX4 cables, InfiniBand
cables do not adhere to the same standard as 10GBase-CX4 cables.
Switch LEDs
Two LED stacks provide system status and port link status. The following illustration
shows the system LEDs.
The system LEDs are described in the following table.
Table 7. System LEDs
Symbol Description
Power supplies and power input status
Fans status
10
IBM System Networking RackSwitch G8000: Installation Guide