IBM QS22 - BladeCenter - 0793, Installation And User Manual

Page: 85 / 114

Appendix A. Using the SMS utility
Use the System Management Services (SMS) utility to perform a variety of
configuration tasks on the BladeCenter QS22 blade server.
Starting the SMS utility
Start the SMS utility to configure the blade server.
1. Establish an SOL session with the blade server. See the BladeCenter
Management Module Command-Line Interface Reference Guide or the
BladeCenter Serial-Over-LAN Setup Guide for more information.
2. Turn on or restart the blade server.
3. When the boot process starts, you see a screen similar to the following:
QS22 Firmware Starting
Check ROM = OK
Build Date = Jan 4 2008 11:31:29
FW Version = "QD-1.26.0-0"
Press "F1" to enter Boot Configuration (SMS)
Press "F2" to boot once from CD/DVD
DDR2 MEMORY INITIALIZATION
CPU0 DIMMs: DIMM1=4096MB DIMM2=4096MB DIMM3=4096MB DIMM4=4096MB
CPU0 timings: 800 MHz, CL=6, tRCD=6, tRP=6
Press F1 to enter the SMS menu.
The SMS utility menu
Select SMS tasks from the SMS utility main menu. Choices on the SMS utility main
menu depend on the version of the firmware in the blade server. Some menu
choices might differ slightly from these descriptions.
PowerPC Firmware
Version QD0123000
SLOF-SMS 1.1 (c) Copyright IBM Corp. 2007 All rights reserved.
--------------------------------------------------------------------------------
Main Menu
1. Select Language
2. Setup Remote IPL (Initial Program Load)
3. Change SCSI Settings
4. Select Console
5. Select Boot Options
6. Firmware Boot Side Options
7. Progress Indicator History
8. FRU Information
9. Change SAS Boot Device
Change SCSI Settings
Select this choice to view and change the addresses of the SCSI controllers
that are attached to the blade server.
Select Console
Select this choice to select the console on which the SMS menus are
displayed.
© Copyright IBM Corp. 2006, 2008
69