3.
Install the retention screw on each system chassis slide rail to further attach the slide rail to the
system chassis.
4.
Next, install the rack slide rails into the rack. Each rack slide rail is marked with either an R (right) or
an L (left), when you look from the front. Select the right slide rail, bring it to the front of the rack,
and locate the selected EIA unit.
5.
From the front of the rack, insert the pins on the front of the slide rail (1) into the holes on the front
of the rack that you previously marked (2). Pull the rail forward so that the rail spring clip (3) latches
Figure 5. Attaching the chassis slide rail to the chassis on the left side of the system
Figure 6. Attaching the chassis rail retention screw to the chassis on the left side of the system
Installing the 7063-CR1 into a rack
7
