IBM Power 750 Express 8408-E8D, Manual

Page: 28 / 66

Installing the cable-management bracket
Use the cable management bracket if you intend to provide extensive organization for the cables and
cords connecting to the system.
Note: The following situations might prevent the installation of the cable-management bracket:
v
The cable management bracket cannot be installed in rack model (7014-S25) due to insufficient
clearance space between the bracket shelf and door.
v
The cable management bracket cannot be installed with features that require the same physical space,
such as the earthquake kit.
v
The cable management bracket might not be able to be installed in racks that contain additional
customer hardware.
The cable management bracket is designed for installation in standard 482.6 cm (19 inch) rack cabinets.
However, the use of other rack designs, or of additional rack features, or of additional customer
hardware might prevent the installation of the cable management bracket.
1. At the rear of the rack, hold the cable management bracket so that its mounting flanges align with
holes in the system chassis.
2. Tighten the two thumbscrews to attach the cable management bracket to the system chassis.
Connecting the expansion units and disk drives
Use this information to learn about connecting and configuring expansion units and disk drives to system
units.
1. For information about connecting expansion units, see Enclosures and expansion units
(http://publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p7ham/expansionunit.htm).
2.
For information about connecting the disk drive unit, see Disk drives (http://
publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p7hal/p7halkickoff.htm).
Figure 18. Installing the cable management bracket
16
Power Systems: Installing the IBM Power 750 (8408-E8D) and IBM PowerLinux 7R4 (8248-L4T)