IBM Power 750 Express 8408-E8D, Manual

Page: 18 / 66

3. Push the power supplies back into the system, ensuring that they are fully seated and latched. Store
the shipping hardware for future use.
Removing the system processor assembly
If you haven't already done so, you must remove the system processor assembly before you install the
IBM Power 750 (8408-E8D) and IBM PowerLinux 7R4 (8248-L4T).
CAUTION:
The system processor assembly requires two people to remove from the system.
Attention: The system processor assembly weighs 45 lbs. Use caution when you are sliding the system
processor assembly out of the enclosure.
1. Prepare to remove the system processor assembly:
a. Using a slotted screwdriver, loosen both the captive screws (A) , if present.
b. Rotate the handles (B) in the direction that is shown until they stop.
c. Hold and pull both the handles and begin sliding the system processor assembly out of the
enclosure until the slide release buttons on each side of the processor assembly lock into place.
Figure 4. Removing the shipping covers
6
Power Systems: Installing the IBM Power 750 (8408-E8D) and IBM PowerLinux 7R4 (8248-L4T)