IBM P260, Installation And Service Manual

Page: 76 / 524

5. Make sure that the slot’s two blue release tabs are in the open position, as indicated in Figure 30 on
page 63.
6.
Orient the network adapter over the system board.
7. Lower the card to the system board, aligning the connectors on the card with its connector on the
system board. Press down gently until the card is firmly seated.
8. Lock the adapter in place by moving the slot’s two blue release tabs into the closed position.
9. Install and close the compute node cover. See “Installing and closing the compute node cover” on
page 41.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before installing the compute node.
10. Install the compute node into the IBM Flex System Enterprise Chassis. See “Installing the compute
node in an IBM Flex System Enterprise Chassis” on page 93.
11. If you replaced the part because of a service action, verify the repair by checking that the amber
enclosure fault LED is off. For more information, see “Compute node control panel button and
LEDs” on page 11.
12. Use the documentation that comes with the expansion card to install device drivers and to perform
any configuration that the expansion card requires.
Removing the battery
You can remove and replace the battery.
About this task
To remove the battery, complete the following steps:
Procedure
1. Read the Safety topic and the “Installation guidelines” on page 35.
Figure 31. Removing the battery
64
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide