IBM P260, Installation And Service Manual

Page: 462 / 524

Perform MAP 3146 in the Systems Hardware information center.
MAP 3147:
Perform MAP 3147 in the Systems Hardware information center.
MAP 3148:
Perform MAP 3148 in the Systems Hardware information center.
MAP 3149:
Perform MAP 3149 in the Systems Hardware information center.
MAP 3150:
Perform MAP 3150 in the Systems Hardware information center.
MAP 3152:
Perform MAP 3152 in the Systems Hardware information center.
MAP 3153:
Perform MAP 3153 in the Systems Hardware information center.
MAP 3190:
Perform MAP 3190 in the Systems Hardware information center.
Error logs
The power-on self-test (POST), the hypervisor, and the service processor write errors to the event log of
the IBM Chassis Management Module.
The following table shows the syntax of a nine-word B700xxxx system reference code (SRC) as it might
be displayed in the event log of the IBM Chassis Management Module (CMM). Additional information
for the event can be viewed by clicking more... in the message field.
The first word of the SRC in this example is the message identifier B7001111. This example numbers each
word after the first word to show relative word positions. The seventh word is the direct select address,
which is 77777777 in the example.
Table 17. Nine-word SRC in the CMM event log
Severity Source Date Message Additional information for event
Critical Blade_05
Jan 21, 2012
07:15 AM
Node
SN#xxxxxxxxxxxx
message: (System
event) system
hardware failure.
more... Firmware. Replace UNKNOWN (5008FECF B7001111
22222222 33333333 44444444 55555555 66666666 77777777
88888888 99999999)
Depending on your operating system and the utilities installed, error messages might also be stored in an
operating system log. For more information, see the documentation that comes with the operating
system.
450
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide