IBM Multiprise 3000 S/390, Installation Manual

Page: 150 / 175

Disabling Service Status
1 Selecting the options
From the Hardware Management Console
Workplace panel.
1. Open Task List from the Views area
2. Open Service from the Task List Work
Area
3. Open Groups from the Views area
4. Drag and drop the Defined CPC's from the
Groups Work Area onto Service Status in
the Service area
5. Select a CPC to customize.
6. Select
Options from the action bar.
7. Select Disable service status from the
pull-down.
8. Repeat 5, 6, and 7 until all CPC's are
disabled.
9. Select Save
10. Select OK
11. Select Cancel to return.
3 Additional Hardware Management Console
From the Hardware Management Console
Workplace panel of the Hardware Management
Console used to complete the install.
1. Open Console Actions from the Views
area
2. Open Save/Restore Customizable
Console Data from the Console Actions
Work Area
3. Insert a blank formatted diskette into drive
"A".
4. choose all data options from the
Customizable Data panel
5. Select Save
6. Take the diskette to the additional
Hardware Management Console perform
the previous steps at those locations
Selecting
Restore instead of Save.
6-72
Installing the System