IBM Multiprise 3000 S/390, Installation Manual

Page: 135 / 175

Accepting Licensed Internal Code Changes (Support Element)
If there are no Support Element LIC Changes to accept go to “Accepting Licensed Internal Code
Changes (Hardware Management Console)” on page 6-58.
This procedure allows you to accept licensed internal code changes as a permanent part of the
Support Element's licensed internal code.
Note: Once a change is accepted, it cannot be removed. A new change must be retrieved and accepted
to replace it.
1 Starting the operation
1. Open Task List from the Views area
2. Open Change Management from the Task
List Work Area
3. Open Groups from the Views area
4. Open Defined CPC's from the Groups
Work Area
5. Select all the CPC's with internal code
changes to be made at one time.
6. Drag and drop the selected object(s) on
Change Internal Code in the Change
Management area.
2 Accepting the changes
The Change Internal Code panel displays.
1. Select Accept installed changes that
were activated from the menu.
2. Select OK .
3 Confirming the request
The Confirm the Action panel displays.
1. Select Accept .
4 Completing the operation
A message stating that the changes have been
accepted or no changes available to accept
displays.
1. Select OK
Chapter 6. Completing the Installation
6-57