IBM LTO, User Manual

Page: 9 / 70

Chapter 1. Installation and user’s guide
The IBM
®
LTO autoloader is an automated storage and retrieval system that comes
with a preinstalled LTO tape drive, three fixed-cartridge slots, and a removable
magazine that can hold six additional tape cartridges. You can connect the
autoloader to a server externally, or you can install the autoloader in a server rack
on a fixed shelf.
The autoloader complies with the ANSI standard for the SCSI-3 LVD (low-voltage
differential) interface and has industry-standard, 68-pin, external SCSI cable
connectors. The tape media format follows ECMA-approved and ANSI-proposed
standards.
Autoloader features
In addition to this book, the option kit includes:
CD
9
10
7
8
«1¬
SCSI external cable
«2¬
SCSI terminator
«3¬
SCSI jumper cable
«4¬
AC power cord
«5¬
Data cartridge
«6¬
Cleaning cartridge
«7¬
Quick install guide booklet
«8¬
Barcode kit
«9¬
Trial software CDs
«10¬
Information tabs
Before you begin
The autoloader requires the following environmental conditions:
v
AC power voltage: autoswitching 100-127 V or 200-240 V. Line frequency: 50-60
Hz.
v
Moderate room temperate between 10-35
°
C (50-95
°
F).
v
Humidity ranging from 20-80%.
v
Standalone configuration includes the base enclosure and feet, and requires the
following clearances:
– Back: 56 cm (22 in.) for cooling and service
– Front: 86 cm (34 in.) for operator access
© Copyright IBM Corp. 2000
1