IBM iSCSI Host Bus Adapter, Manual

Page: 32 / 62

18. Highlight Chap Name using the up or down arrow keys and press Enter to select. This will bring up
the Enter Chap Name pane. Type in the CHAP name from the iSCSI Network Planning Worksheets
item CQ13 and press Enter.
19.
Highlight Chap Secret using the up or down arrow keys and press Enter to select. This will bring
up the Enter New Secret pane. Type in the chap secret from the iSCSI Network Planning Worksheets
item CQ14 and press Enter and confirm by retyping the same chap secret on the next pane and press
Enter.
20. Highlight Bidirectional Chap using the up or down arrow keys and press Enter to change the value
to Disabled , since this feature is not supported.
21. Press Esc to return to the Primary Boot Device Settings menu.
22.
Press Esc to return to the iSCSI Boot Settings menu.
23. Press Esc to return to the Configuration Settings menu.
Configure iSCSI HBA port settings
After configuring for either manual or dynamic addressing, use the procedure in this section to complete
the selected iSCSI HBAs port configuration.
1. Highlight Advanced Adapter Settings using the up or down arrow keys and press Enter.
2. Highlight Delayed ACK using the up or down arrow keys and press Enter until the value shows
Disabled .
3. Highlight MTU (maximum transmission unit) using the up or down arrow keys and press Enter until
the value shows the desired frame size setting from the iSCSI Network Planning Worksheets item CQ16
(either 1500 or 9000). Ensure the network the iSCSI HBA will be attached to supports the value
selected here.
4.
Press Esc to return Configuration Settings menu.
5. Press Esc. Highlight Save changes using the up or down arrow keys and press Enter to select.
Note: This may take several minutes to complete and will remain with the same pane on the screen
until completion. At completion of the save, the Fast!UTIL Options menu will be displayed.
Disable boot for additional iSCSI HBA ports
iSCSI HBA ports other than the boot device need to be configured with boot mode disabled. Use the
procedure in this section to accomplish this task.
1. Press Esc Highlight Return to Fast!UTIL and press Enter.
2.
From the Select Host Adapter menu, find any unused adapter ports and check to see if the
Adapter
Boot Mode
is already set to
Disable
. If so, there is no need to continue. Otherwise, highlight the
unused adapter port using the up or down arrow keys and press Enter to select. It may take several
seconds for the next screen to appear.
3. On the Fast!UTIL Options menu, highlight Configuration settings using the up or down arrow keys
and press Enter to select.
4. On the Configuration Settings menu , highlight iSCSI Boot Settings using the up and down arrow
keys and press Enter to select.
5. Highlight Adapter Boot Mode using the up or down arrow keys and press Enter to select.
6. Highlight Disable using the up or down arrow keys and press Enter to select.
7. Press Esc to return to the Configuration Settings menu.
8. Highlight Advanced Adapter Settings using the up or down arrow keys and press Enter.
9.
Highlight
MTU
(maximum transmission unit) using the up or down arrow keys and press Enter
until the value shows the desired frame size setting from the iSCSI Network Planning Worksheets item
CQ16 (either 1500 or 9000). Ensure the network the iSCSI HBA will be attached to supports the value
selected here.
10. Press Esc to return Configuration Settings menu.
20
System i and System p: iSCSI Host Bus Adapter for IBM BladeCenter, System x, or xSeries