IBM IntelliStation Z Pro 6221, Hardware Maintenance Manual

Page: 62 / 168

9. Remove the retainer from the left side of the diskette drive and place it on the
new diskette drive.
10. Install the diskette drive by sliding the drive into the bay so that the metal tab
of the drive aligns with the oval cutout and the drive locks into place; then,
connect the cables at the rear of the drive.
11. If you have other options to install or remove, do so now.
12. Replace the support bracket (see “Removing and installing the support
bracket” on page 42).
13. Replace the bezel (see “Front bezel” on page 40).
14. Replace the side cover (see “Replacing the side cover” on page 62).
15. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing a hard disk drive in bay 4, 5, or 6
Bays 4, 5, and 6 are in the drive cage. The drive cage is behind the front of the
adapter-support bracket.
Note: You might find it useful to work with the computer laying on its side.
Complete the following steps to install a drive in bay 4, 5, or 6:
1. Follow the instructions in “Preinstallation steps” on page 49.
2. Turn off the computer and all attached devices.
3. Disconnect all power cords; then disconnect all external cables.
4. Remove the side cover (see “Removing the side cover” on page 39).
5. Remove the support bracket (see “Removing and installing the support
bracket” on page 42).
6. Grasp the drive cage and rotate the cage out of the computer until it locks into
place with the drive-cage retention tab and the open ends of the drive slots
and installed drives are facing you. Ensure that the drive cage locks into place
over the drive-cage retention tab by rotating the drive cage all the way out of
the computer.
13
94
52
IBM IntelliStation Z Pro Type 6221: Hardware Maintenance Manual