IBM Infoprint 1410, User Manual

Page: 79 / 254

Print media specifications and guidelines
76
Media specifications and guidelines
• Load envelopes with the flap side down and the stamp area entering last.
Note: For best results, peel-and-stick envelopes should exit to the rear output bin. Open
the rear output bin when printing on these envelopes.
Do not feed stamped envelopes into the multipurpose feeder. The stamp and addresses are
shown for envelope orientation only.
5
Slide the print media into the multipurpose feeder slot as far as it will go without damaging the
print media.
6
Slide the width guide to the left until it lightly touches the edge of the stack.
Make sure the print media fits loosely in the multipurpose feeder and is not bent or wrinkled.
7
Set the paper size and paper type in the menus from the control panel.
Stack height limiter