IBM Infoprint 1410, User Manual

Page: 15 / 254

Safety information
12
Notices
Safety information
• If your product is not marked with this symbol , it must be connected to an electrical outlet
that is properly grounded.
CAUTION: Do not use the fax feature during a lightning storm. Do not set up this product or
make any electrical or cabling connections, such as the power cord or telephone, during a
lightning storm.
• The power cord must be connected to an electrical outlet that is near the product and easily
accessible.
• Refer service or repairs, other than those described in the operating instructions, to a
professional service person.
• This product is designed, tested, and approved to meet strict global safety standards with the
use of specific Lexmark components. The safety features of some parts may not always be
obvious. Lexmark is not responsible for the use of other replacement parts.
• Your product uses a laser.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
• Your product uses a printing process that heats the print media, and the heat may cause the
print media to release emissions. You must understand the section in your operating
instructions that discusses the guidelines for selecting print media to avoid the possibility of
harmful emissions.
• This product contains mercury in the lamp (<5mg Hg). Disposal of mercury may be regulated
due to environmental considerations. For disposal or recycling information, contact your local
authorities or the Electronic Industries Alliance: www.eiae.org.
Cautions and warnings
CAUTION: A caution identifies something that might cause you harm.
Warning: A warning identifies something that might damage your MFP hardware or software.
Electronic emission notices
Federal Communications Commission (FCC) compliance
information statement
The MFP, Type 4541-001, has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The FCC Class A limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and