IBM iDataPlex dx360 M4, User Manual

Page: 22 / 86

Table 1. Features and specifications
Microprocessor:
v
Supports up to two Intel Xeon
™
E5-2600/E5-2600 v2 series multi-core
microprocessors (one installed)
v Level-3 cache
v QuickPath Interconnect (QPI) links
speed up to 8.0 GT per second
Note:
v
Use the Setup utility program to
determine the type and speed of the
microprocessors.
v For a list of supported microprocessors,
see http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us/.
Hard disk drives: Each system-board tray
supports either one 3.5-inch simple-swap
SATA hard disk drive bay or up to two
2.5-inch solid-state drives.
Memory:
v
Sixteen DIMM connectors (with eight
DIMMs and eight fillers installed)
v
Total memory: up to 64 GB
v
Type:
– 4 GB dual-rank registered PC3-12800
double-data-rate 3 (DDR3) 1600 MHz
SDRAM DIMMs
– 8 GB dual-rank registered PC3-14900
double-data-rate 3 (DDR3) 1866 MHz
SDRAM DIMMs
v
Chipkill memory protection
Size:
v 2U chassis:
– Depth: 56.8 cm (22.4 inches)
– Width (EIA flange to EIA flange outer
edge): 48.6 cm (19.1 inches)
– Height: 8.78 cm (3.46 inches)
– Weight (with 2 fully configured nodes,
PSU and PSU filler): 21.5 kg (47.5 lb)
v
1U node:
– Depth: 55.8 cm (22.0 inches)
– Width (cam lever tip-to-tip): 47.3 cm
(18.6 inches)
– Height: 4.15 cm (1.63 inches)
– Weight (fully configured with 8x
dimms, 8x dimm fillers, 8x memory
springs, water loop, and infinite band
card): 7.39 kg (16.3 lb)
v
Water:
– Required water to fill the node: 70
grams (0.07 liter)
– Required water to fill the rack
manifold: 7 kg (7 liters)
– Maximum pressure: 4.4 bars
Integrated functions:
v Integrated Management Module II
(IMM2), which consolidates multiple
management functions in a single
chip.
v
Intel I350AM4 Quad Port Gigabit
Ethernet controller with Wake on LAN
support
v
Eight Universal Serial Bus (USB) 2.0
ports (three front and four rear of the
chassis, and one near the SAS/SATA
RAID riser card in which the optional
USB flash device with embedded
hypervisor software is installed)
v
Six network ports (four 1 Gb Ethernet
ports on the system board and two
additional ports when the optional IBM
Dual-Port 10 Gb Network Daughter
Card is installed)
v
One System Management RJ-45 on
the rear to connect to a systems
management network. This system
management connector is dedicated
to the IMM2 functions.
v One serial port
Predictive Failure Analysis (PFA)
alerts:
v
Memory
v
Hard disk drives
Environment:
v
Air temperature:
– Server on: 5°C to 40°C (41°F to
104°F); altitude: 0 to 950 m (0 to
3116 ft). Derate maximum
temperature by 1°C for every 175
m (574 ft) increase in elevation to
a maximum of 3050 m (10004 ft) at
an ambient temperature of 24°C
– Server off: 5°C to 45°C (41°F to
113°F); maximum altitude: 3050 m
(10004 ft)
v
Humidity:
– Server on: 8% to 85%
– Server off: 8% to 85%
v Particulate contamination:
Attention: Airborne particulates and
reactive gases acting alone or in
combination with other environmental
factors such as humidity or
temperature might pose a risk to the
server. For information about the limits
for particulates and gases, see
“Particulate contamination” on page
59.
Environment: (cont.)
v
Water Temperature:
– Minimum Temperature: 18 °C (may
adjust based upon dew point)
– Maximum Temperature: 45 °C
v
Rack Water Flow Rate:
– Minimum Rack flow rate: 30 lpm
– Nominal Rack flow rate: 37 lpm
– Maximum Rack flow rate: 63 lpm
v Water Treatment:
– The water must be treated with
anti-biological and anti-corrosion
measures.
– IBM Part Number 00J0351 is the
specification that describes the details
for the IBM required water treatment.
Power supply:
v Support one 900-watt ac power supply
Electrical input:
v Sine-wave input (50 - 60 Hz) required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA),
approximately:
– Minimum: 0.150 kVA
– Maximum: 0.839 kVA
Notes:
1. Power consumption and heat output
vary depending on the number and type
of optional features installed and the
power-management optional features in
use.
2. The sound levels were measured in
controlled acoustical environments
according to the procedures specified
by ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby noise
sources. The noise emission level
stated in the declared (upper limit)
sound-power level, in bels, for a
random sample of system.
6
System x iDataPlex dx360 M4 Types 7918 and 7919: User’s Guide