IBM iDataPlex dx320 6385, User Manual

Page: 32 / 60

Removing the system-board tray cover
Release
latch
System-board
tray cover
System-board
tray
To remove the system-board tray cover, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 15).
3. If the system-board tray is installed in a chassis, remove it (see “Removing a
system-board tray from a 2U chassis” on page 19).
4. Carefully set the system-board tray on a flat, static-protective surface, with the
cover side up.
5. Pull the cover release latch on each side of the system-board tray upward; then,
lift the cover open.
6. Lift the cover off the system-board tray and store it for future use.
Note: If two system-board trays are installed in a 2U chassis, both must have their
covers installed.
20
IBM iDataPlex dx320 User's Guide