IBM IC35L040AVVN07-0 - 40GB IDE Deskstar 120GXP 7200RPM UATA-100..., Specifications

Page: 158 / 211

11.23 Security Erase Unit (F4h)
see below Status 1 1 1 1 0 1 0 0 Command
- - - - - - - - Device/Head 1 - 1 D - - - - Device/Head
- - - - - - - -
Cylinder High
- - - - - - - -
Cylinder High
- - - - - - - - Cylinder Low - - - - - - - - Cylinder Low
- - - - - - - - Sector Number - - - - - - - - Sector Number
- - - - - - - -
Sector Count
- - - - - - - -
Sector Count
see below Error - - - - - - - - Feature
- - - - - - - - Data - - - - - - - - Data
7 6 5 4 3 2 1 0
Register
7 6 5 4 3 2 1 0
Register
Command Block Input
Registers
Command Block Output
Registers
V – 0 – V 0 V 0 0 0 V 0 V 0 0 0
ERR IDX COR DRQ DSC DF RDY BSY AMN T0N ABT 0 IDN 0 UNC CRC
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Status Register Error Register
Figure 122. Security Erase Unit Command (F4h)
The Security Erase Unit command initializes all user data sectors and then disables the device lock
function.
Note that the Security Erase Unit command initializes from LBA 0 to Native MAX LBA. The Host MAX LBA
set by the Initialize Drive Parameter or the Set MAX Address command is ignored. So the protected area
by the Set MAX Address command is also initialized.
This command requests the transfer of a single sector data from the host including the information
specified in the figure below.
If the password does not match, the device rejects the command with an Aborted error.
Reserved 17-255
Password (32 bytes ) 01-16
Control Word
bit 0 : Identifier (1- Master, 0- User)
bit 1 : Erase mode (1- Enhanced, 0- Normal)
Enhanced mode is not supported
bit 2-15: Reserved
00
Description Word
Figure 123. Erase Unit Information
Deskstar 120GXP hard disk drive specifications
144