IBM FAStT200 HA, Installation And User Manual

Page: 68 / 114

50
IBM FAStT200 and FAStT200 HA Storage Servers Installation and User’s Guide
Installing a hot-swap power supply
Note: When replacing a power supply that has failed, ensure that the power supply
latch is mounted on the side of the power supply that faces the middle of the
storage server. If it is not, remove the lever screw, flip the lever over, and
tighten the screw on the opposite side.
To install a hot-swap power supply:
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact a
service technician.
1. Ensure that the ac power switch is off on the power supply that you are installing.