Figure 6: Load the Device onto the Lift
3.
Using the lift, position the device in the rack:
■
For two-post rack mounting, align the bottom hole in each mounting bracket
with a hole in each rack rail.
■
For four-post rack or cabinet mounting, position the device so that the bottom
rear edge of the chassis rests on the support shelf you installed earlier as
shown in Figure 5 on page 7.
4.
Install a mounting screw into each of the two aligned holes as shown in Figure
7 on page 9 (two-post rack) or Figure 8 on page 9 (four-post rack). Use a
number-2 Phillips screwdriver to tighten the screws.
8
■
Step 3: Install the Device
IBM Ethernet Appliance J34S Getting Started Guide
