IBM eServer xSeries 345 Type 8670, User Manual

Page: 39 / 68

Assist will start, and information about the tree object will appear in the right pane.
Using the LSI Logic Configuration Utility program
You can use the built-in, menu-driven LSI Logic Configuration program to:
v
Perform a low-level format on a hard disk drive
v
Set the SCSI device scan order
v
Set the SCSI ID for a controller
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
RAID level 1 operation.
2. If your server has a ServeRAID-5i controller installed, you can use ServeRAID
Manager to configure the integrated SCSI controller with RAID capabilities for
additional RAID levels.
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server and watch the monitor screen.
2. When the
Press CTRL C to start LSI Logic Configuration Utility
prompt
appears, press Ctrl+C.
Note: If an administrator password has been set, a prompt appears asking you
to type the password to start the LSI Logic Configuration Utility program.
3. Use the arrow keys to select a controller (channel) from the list of adapters;
then, press Enter.
4. Follow the instructions on the screen to change the settings of the selected
items; then, press Enter.
Chapter 2. Configuring your server
27