IBM eServer xSeries 236, User Manual

Page: 24 / 66

Rear view
The following illustration shows the connectors and LEDs on the rear of the server.
Keyboard connector
Mouse connector
Serial 1 connector
Serial 2 connector
USB 1 connector
ASM
Remote Supervisor
Adapter II
SlimLine Ethernet
Video connector
Ethernet link LED
Ethernet activity LED
Power cord connector
AC power LED
DC power LED
USB 2 connector
Parallel connector
Ethernet link 2
status LED
Ethernet connectors 1 and 2
Ethernet link 1
status LED
PO
WER SUPPL
Y
FILLER
REQ
UIRED FOR
SYSTEM COOLING WITH EMPTY SLO
T
DO NO
T
THR
O
W
A
W
A
Y
A
TTENTION:
PO
WER SUPPL
Y
FILLER
REQ
UIRED FOR
SYSTEM COOLING WITH EMPTY SLO
T
DO NO
T
THR
O
W
A
W
A
Y
A
TTENTION:
Keyboard connector: Connect a PS/2
®
keyboard to this connector.
Mouse connector: Connect a mouse or other PS/2 device to this connector.
Parallel connector: Connect a parallel device to this connector.
Serial 1 connector: Connect a 9-pin serial device to this connector.
USB 1 connector: Connect a USB device to this connector.
Ethernet link 1 status LED: This LED is on the Ethernet connector. When this
LED is lit, there is an active connection on the Ethernet port 1.
Ethernet connectors 1 and 2: Use these connectors to connect the server to a
network.
Ethernet link 2 status LED: This LED is on the Ethernet connector. When this
LED is lit, there is an active connection on the Ethernet port 2.
Serial 2 connector: Connect a 9-pin serial device to this connector.
Video connector: Connect a monitor to this connector.
USB 2 connector: Connect a USB device to this connector.
DC power LED: This green LED provides status information about the power
supply. During typical operation, both the ac and dc power LEDs are lit. For any
other combination of LEDs, see the Hardware Maintenance Manual and
Troubleshooting Guide on the IBM xSeries Documentation CD.
12
IBM xSeries 236 Type 8841: User’s Guide