IBM eserver 630 6C4, Service Manual, Page: 389 / 573

Bezels
Before performing the following procedure, read the “Safety Notices” on page xi.
Front Bezel Removal (Model 6C4)
To remove the bezel, do the following:
1. Open the front rack door and place the system into the service position as
described in “Placing the Model 6C4 into the Service Position” on page 355.
2. Press in on both bezel-release tabs at the same time. See the following illustration
for bezel-release tab locations.
3. Gently pull the bezel away from the system.
4. Put the bezel in a safe place.
1 Rack Door 3 Bezel Release Tab (Located on each side of
bezel)
2 Bezel 4 19-Inch Rack
Front Bezel Replacement (Model 6C4)
To replace the front bezel, do the following:
1. Open the front rack door and place the system into the service position as
described in “Placing the Model 6C4 into the Service Position” on page 355.
2. Seat the two tabs located on the bottom edge of the bezel into their mating slots
located on the bottom edge of the system.
3. Pivot the bezel up, aligning the release tabs to the mating slots located on the front
of the system.
4. Gently push the tabs into the slots until the bezel seats against the front of the
system.
5. Push the system drawer back into the operating position as described in “Returning
the Model 6C4 to the Operating Position” on page 356.
6. Close the rack door.
Chapter 9. Removal and Replacement Procedures
369