IBM eserver 630 6C4, Service Manual, Page: 329 / 573

Modem Configuration Menu
Note: This option applies only to a modem attached to serial port 1 (S1) or serial port 2
(S2) on the CEC backplane.
The first two lines of the Modem Configuration Menu contain status of the current
selections. Selections are made in the sections labeled Modem Ports and Modem
Configuration File Name. Select the serial port that you want to activate and then select
the modem configuration file for the modem on the port. If you want to set up all of the
serial ports with modems, make your selections one port at a time.
Modem Configuration Menu
Port 1 Modem Configuration File Name:
Port 2 Modem Configuration File Name:
To make changes, First select the port and then the configuration file
name
Modem Ports:
1. Serial port 1
2. Serial port 2
Modem Configuration File Name:
5. none9. modem_z_sp
6. modem_f_sp
10. modem_m1_sp
7. modem_f0_sp 11. modem_m0_sp
8. modem_f1_sp 12. modem_m1_sp
30. Save configuration to NVRAM and Configure modem
98. Return to Previous Menu
0>
For information on choosing a modem configuration file, see “Sample Modem
Configuration Files” on page 517 and “Transfer of a Modem Session” on page 523.
Chapter 7. Using the Service Processor
309