IBM EN4093R, User Manual

Page: 34 / 60

3. Enter the switch user ID and password and click OK . The default user ID is
USERID
. The default password is
PASSW0RD
(where the sixth character is the
number zero, not the letter O).
Note: The passwords that are used to access the switch are case-sensitive. To
increase system security, change the password after you log on for the first
time.
Initial configuration
The operating firmware on the switch contains default configuration files that are
installed during the firmware installation. These initial configuration settings are not
in a separate configuration file but are components of the firmware. When you
restore the management module to factory defaults, the original configuration is
restored. For more information about configuring and managing the switch, see the
Command Reference for the switch.
Logging in to the switch
The switch supports user-based security that enables you to prevent unauthorized
users from accessing the switch or changing its settings.
To log in to the switch, complete the following steps.
1. At the prompt, type your user name and press Enter . The default user name is
USERID .
2. Type your password and press Enter . The default password is
PASSW0RD
(where
the sixth character is the number zero, not the letter O). The main-menu window
opens.
After you log on to the switch, you must set the date and time. See the Command
Reference for the switch to perform this task and others as needed.
24
EN4093 and EN4093R 10 Gb Scalable Switch: User's Guide