IBM Elastic Storage System 3200, Hardware Planning And Installation Manual

Page: 30 / 156

Checking internal devices
Ensure that you complete an internal device check before you install or service your system.
To conduct the internal device check, use the following steps.
1. Check for any non-IBM changes that were made to the device.
2. Check the condition of the inside of the device for any metal or other contaminants, or any indications
of water, other fluid, fire, or smoke damage.
3. Check for any obvious mechanical problems, such as loose components.
4. Check any exposed cables and connectors for wear, cracks, or pinching.
Handling static-sensitive devices
Ensure that you understand how to handle devices that are sensitive to static electricity.
Attention: Static electricity can damage electronic devices and your system. To avoid damage,
keep static-sensitive devices in their static-protective bags until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following precautions:
• Limit your movement. Movement can cause static electricity to build up around you.
• Handle the device carefully, holding it by its edges or frame.
• Do not touch solder joints, pins, or exposed printed circuitry.
• Do not leave the device where others can handle and possibly damage the device.
• While the device is still in its antistatic bag, touch it to an unpainted metal part of the system unit for at
least 2 seconds. (This action removes static electricity from the package and from your body).
• Remove the device from its package and install it directly into your system, without putting it down. If it
is necessary to put the device down, place it onto its static-protective bag. (If your device is an adapter,
place it component-side up.) Do not place the device onto the cover of the system or onto a metal table.
• Take additional care when you handle devices during cold weather. Indoor humidity tends to decrease
in cold weather, causing an increase in static electricity.
Sound pressure
Attention: Depending on local conditions, the sound pressure can exceed 85 dB(A) during service
operations. In such cases, wear appropriate hearing protection.
Environmental notices
This information contains all the required environmental notices for IBM Systems products in English and
other languages.
The IBM Systems Environmental Notices includes statements on limitations, product information, product
recycling and disposal, battery information, flat panel display, refrigeration and water-cooling systems,
external power supplies, and safety data sheets.
FCC certification
The FCC certification pertains solely to the ESS itself. Any components that are installed by the customer
might impact the certifications, and it is the customer’s responsibility to ensure that the certification
requirements are met in the geography where the ESS will be used.
Electromagnetic compatibility notices
The following Class A statements apply to IBM products and their features unless designated as
electromagnetic compatibility (EMC) Class B in the feature information.
When attaching a monitor to the equipment, you must use the designated monitor cable and any
interference suppression devices that are supplied with the monitor.
12 IBM Elastic Storage System 3200: Hardware Planning and Installation Guide