Quick installation guide
Ultrastar 9LZX & 18ZX
Multi-mode SE/LVD
Models: DRVS-09V
DRVS-09D
DRVS-18V
DRVS-18D
IBM storage products
Page 1
IBM Hard Disk Drive Technical Support Center version 4.0
Handling precautions
1.
Do not cover the breather hole!
Covering the
breather hole may result in loss of
data.
2.
Do not press on the drive!
Do not apply any force
to the drive during handling or installation.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic dis-
charge (ESD).
4. Do not open the static-protective bag containing the
drive until required. Static electricity can damage the
drive.
5. Turn off and unplug your computer before removing
the case.
6. When you are installing the drive, touch the
static-protective package containing the drive to a
grounded, unpainted metal surface for at least two
seconds. (This drains static electricity from the
package and from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save your drive packaging materials including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging.
Quick installation procedure
Backup all data before proceeding with the installation
This procedure may require the use of a bootable
System Diskette containing FDISK.COM and
FORMAT.COM
Setting the address
1.
Each drive on the SCSI bus must have a unique
address. Sixty eight and eighty pin (Wide SCSI)
devices have 16 possible addresses.
2. SCSI address bits 3,2,1, and 0 of the 32 pin Option
Jumper Block are used to select the SCSI device ID.
0
1
10 12 14 16 18
Ground
Ground
Termination
Power Enable
1
3
5
7
11 13 15 17 19 21 23 25 27 29 31
2
4
6
8
20 22 24 26 28 30 32
+5V
2
SCSI ID
Bits
3
Blank
Ground
External Activity LED Write Protect
Auto Start Delay
Disable Sync Negotiations
Disable SCSI Parity
Disable Unit Attention
Auto Start
Reserved
Disable Wide
Negotiations
Ground
Reserved
Force Single
Ended Mode
Note: In the table below, “off” means a jumper is not in place and
“on” means a jumper is in place.
15
on
on
on
on
14
off
on
on
on
13
on
off
on
on
12
off
off
on
on
11
on
on
off
on
10
off
on
off
on
9
on
off
off
on
8
off
off
off
on
7
on
on
on
off
6
off
on
on
off
5
on
off
on
off
4
off
off
on
off
3
on
on
off
off
2
off
on
off
off
1
on
off
off
off
0
off
off
off
off
Address
Bit 0
Bit 1
Bit 2
Bit 3
