IBM Deskstar Deskstar 3, User Manual

Page: 271 / 392

Configuring Printer For Push-Pull Forms Path
To configure the printer for the Push-Pull forms path:
1.
Power on (|) the printer
2. Wait until the message
IBM 4247
appears, all the segments of the LCD on the
operator panel display arelighted, and the printer has stopped all motion.
3. Press Menu to enter configuration.
4. Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Rear Tractor Use
5.
Press Enter.
6. Press Scroll
↑
or Scroll
↓
until the printer displays
Rear Tractor Use
Push-Pull
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Return to return to the Configuration Menu.
If you want the Push-Pull forms path to be the default path used, then
continue with the next step.
9.
Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Printer Setup
10. Press Enter.
11. Press Scroll
↑
or Scroll
↓
until the printer displays
Printer Setup
Paper Source
12.
Press Enter.
13. Press Scroll
↑
or Scroll
↓
until the printer displays
Paper Source
Front
14. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
15. Press Start or Return to exit the Menu. See “Exiting the Configuration Menu”
on page 55 for instructions.
Loading Forms for Push-Pull
Note:
Before you start this procedure, see Forms Stack Input and Output Locations
in Chapter 19, “Supplies, Optional Features, and Maintenance” for
information on stacking height limits.
To load forms in the Front Push tractors:
Chapter 17. Setting Up Forms Paths
261