IBM Deskstar Deskstar 3, User Manual

Page: 118 / 392

Standard (Default)
The printer will execute an automatic New Line function before the start of
an OILC (Operator Initiated Local Copy) job, unless a Form Feed was the
last function executed.
Alternate
The printer will execute an automatic Form Feed function before the start
of an OILC (Operator Initiated Local Copy) job, unless a Form Feed was
the last function executed.
Note: The printer performs a partial reset to put any change to this parameter
value into effect when you exit the Configuration Menu with Start or
Return
. Buffered data will be lost.
To change or check the automatic function before start of OILC job, follow these
steps:
1. Press Menu.
2. Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Coax Configuration
3. Press Enter.
4.
Press Scroll
↑
or Scroll
↓
until the printer displays
Coax Configuration
Printer Compatibility
5.
Press Enter.
6. Press Scroll
↑
or Scroll
↓
until the printer displays
Printer Compatibility
12 (Auto before OILC)
7. Press Enter to display the current value.
8. Press Scroll
↑
or Scroll
↓
until the desired value for automatic function after
end of OILC job value is displayed.
9.
Press Enter.
An asterisk (*) will be displayed in front of the selected value.
10.
Press Start or Return to exit the Menu. See “Exiting the Configuration Menu”
on page 55.
Form Feed Suppression
Form Feed Suppression is a selection that determines whether the printer will act
on or ignore a Form Feed command that is received when the printer is already at
the first print position at the top of the form.
This function applies in all Coax non-IPDS environments. It does not apply to the
IPDS data stream.
You can set the Form Feed Suppression selection to either of the following values:
Disabled (default)
The printer will act on all Form Feed commands
108
4247 Model 003 User’s Guide