IBM CT-618, Installation Manual, Page: 18 / 84

IBM Telephony Installations
IBM CTS Installation Guide 12
g) Click Next.
h) When setup successfully completes, click Close.
5. Acrobat Reader Installation
a) The Welcome screen will display. After reading, click Next.
b) The License Agreement will display. If you agree with the license
terms, click Next. If you do not agree, click Cancel to stop the
installation.
c) Choose destination folders for the Acrobat Reader software.
d) Setup will continue. You will be prompted to view the read me file
(optional). Click finish..
e) When complete, click OK.
6. If you are installing CT-618 boards , power down the server and install
boards according to the Hardware Installation instructions on page 17. (If
CT-618 boards are already installed in the server, power down the server and
proceed to Step 7.)
7. Upgrade the CT-618 board firmware:
Note: If your server is set up as NTFS: During the board firmware update
process you will need to run in DOS mode. Since NTFS is not visible from
DOS, you will need to access required files from a FAT partition or a
diskette. If you are not installing the IBM Telephony software to a FAT
partition, you will need to copy the following files from the
IBMCT/SYSTEM folder to a FAT partition (or to a diskette):
BOOTLOAD.HEX, MONITOR.HEX, NETPHO32.HEX and NL.EXE.
a) Restart the server in DOS. (Note: A DOS window will not work.) You
may need to boot with a DOS boot disk if your server is not set up to
boot in DOS.
b) Go to C:/IBMCT/SYSTEM (or the drive you selected during
installation) and enter the following command from the DOS prompt:
NL -B -LNETPHO32.HEX
This loads the firmware using default I/O port and IRQ settings (I/O
Port 3e0, IRQ 5). If not using these defaults, refer to Specifying and
changing board settings on page 31 for instructions on specifying values